- Standard
- Laboratory Water Valves
- High Flow Water Valves
- laboratory single faucets
- laboratory mixing faucets
- combination fixtures
- Foot-Operated faucets
- Pre-Rinse units
- Pure Water Faucets
- pressure regulator fixtures
- fine control needle valves
- needle valves
- steam valves
- laboratory ball valves
- remote control valves
- remote control outlet fittings
- electrical fixtures
- apparatus & lattice rod Assy's
- accessories & components
- Vandal-Resistant
- ColorTech
- Laboratory Water Valves
- Laboratory Single Faucets
- Laboratory Mixing Faucets
- Multiple Outlet Water Fixtures
- Foot-Operated Faucets
- Pre-Rinse Units
- Pure Water Faucets
(Tin-Lined Brass) - Pure Water Faucets
(Plastic-Lined) - Pure Water Faucets
(Stainless Steel) - Ultra-High Purity Gas Fittings
- High Purity Gas Fittings
- Fine Control Needle Valves
- Fine Control Needle Valves (Stainless)
- Needle Valves
- Steam Valves
- Laboratory Ball Valves
- Push/Turn Gas Valves
- Lift/Turn Gas Valves
- Remote Control Fittings Valves
- Remote Control Outlet Fittings
- Electrical Fittings
- Accessories and Components
- Engineering Information
- Laboratory Safety
CT740FCN-784-QR
Pressure Regulator Fitting, Fume Hood Mounting
Application: Regulation and control of high purity gases in fume hoods. Used for compressed air and inert gases, including nitrogen, helium, argon and oxygen. Fittings are specially cleaned, assembled and packaged for use with 99.999% pure (5.0) gases.
Finish: Fittings are available with a choice of six powder coated finishes. Specify finish when ordering: white, gray, tan, polished chrome with clear epoxy, satin nickel with clear epoxy or satin chrome with clear epoxy.
FlowStop: Fittings are available with optional FlowStop. FlowStop may be used to shut off gas supply for maintenance and to regulate volume of flow.
Mounting: Pressure regulator, gauge and valve are panel mounted on front face of fume hood. Components are piped together behind face of hood for clean, neat installation.
Regulator: Non-relieving type with brass body and neoprene diaphragm. Inlet pressure range 5-300 PSI. Outlet pressure range 5-125 PSI.
Valve: Panel mounted fine control needle valve for precise flow control. See page 57 for information on valve.
Outlet Fitting: Outlet fitting for installation inside hood has removable quick connect with 1/4” IPS male plug.
Quality Assurance: Fitting is specially cleaned, fully assembled and factory tested prior to shipment.
Additional Model:
CT740FCN-784-MR Same as above except with 1/4” OD compression fitting outlet inside fume hood.
Note: This fitting may also be used with CT739FCN, CT750FCN and CT752FCN remote control valves.
