- Standard
- Laboratory Water Valves
- High Flow Water Valves
- laboratory single faucets
- laboratory mixing faucets
- combination fixtures
- Foot-Operated faucets
- Pre-Rinse units
- Pure Water Faucets
- pressure regulator fixtures
- fine control needle valves
- needle valves
- steam valves
- laboratory ball valves
- remote control valves
- remote control outlet fittings
- electrical fixtures
- apparatus & lattice rod Assy's
- accessories & components
- Vandal-Resistant
- ColorTech
- Laboratory Water Valves
- Laboratory Single Faucets
- Laboratory Mixing Faucets
- Multiple Outlet Water Fixtures
- Foot-Operated Faucets
- Pre-Rinse Units
- Pure Water Faucets
(Tin-Lined Brass) - Pure Water Faucets
(Plastic-Lined) - Pure Water Faucets
(Stainless Steel) - Ultra-High Purity Gas Fittings
- High Purity Gas Fittings
- Fine Control Needle Valves
- Fine Control Needle Valves (Stainless)
- Needle Valves
- Steam Valves
- Laboratory Ball Valves
- Push/Turn Gas Valves
- Lift/Turn Gas Valves
- Remote Control Fittings Valves
- Remote Control Outlet Fittings
- Electrical Fittings
- Accessories and Components
- Engineering Information
- Laboratory Safety
EW1016
Drench Hose Unit, Wall Mounted
application: Drench hose unit for wall mounting. Ideal for rinsing any part of user’s eye, face or body.
Note: Under ANSI Z358.1 - 2004, drench hose units supplement, but do not replace, other types of emergency equipment.
spray head: Single FS-Plus™ spray head. Spray head has “flip top” dust cover, internal flow control and filter to remove impurities from the water flow.
valve: Forged brass squeeze valve activated by stainless steel lever handle. Valve has replaceable stainless steel seat for exceptional durability. Valve closes when lever handle is released.
hose: 12' reinforced nylon retractable coiled hose.
180 PSI maximum working pressure.
mounting: Bracket with spring clips to hold unit on wall. Clips position spray head and handle to face forward at all times.
backflow preventer: In-line dual backflow preventer installed on inlet of hose (EW1016BP only). Note: Check with code authority for compliance with local plumbing code.
supply: 3/8" NPT female inlet.
sign: ANSI-compliant identification sign.
quality assurance: Unit is completely assembled and water tested prior to shipment.
Additional Options:
- BP In-line dual check backflow preventer installed on inlet of hose. Note: Check with code authority for compliance with local plumbing code..
- DC Stainless steel dust cover for spray head.
- LC Locking clip for valve handle. Valve stays open until locking clip is released.
- VB In-line vacuum breaker for installation between valve and spray head.
- TMV AP3600 thermostatic mixing valve precisely blends hot and cold water to deliver warm (tepid) water as required by ANSI Z358.1-2004. Refer to “Tempering Units” section for complete technical and product selection information.
