WaterSaver manufactures a complete line of components for lattice rod assemblies. A wide variety of assemblies for installation on bench tops and in fume hoods may be constructed using these components. Components are available in a choice of materials, as follows:

Aluminum. All components are machined from solid aluminum bar stock and polished to a satin (brushed) finish.

Plastic. Flanges and clamps are molded in black nylon for strength and chemical resistance. Rods are fabricated in white fiberglass.

Stainless Steel. Stainless steel components offer superior strength and corrosion resistance for even the most demanding applications. All components are machined from Type 316 stainless steel bar stock and polished to a satin finish.

The rods listed below are representative of the most commonly used sizes. Rods can be fabricated in any length up to 120".

 

  Aluminum Plastic Stainless Steel
Flanges      
Flange with Set Screw for 1/2” Plain Rod AAP158 PAP158 SAP158
Flange with Thread for 1/2” Threaded Rod AAP158A   SAP158A
Threaded Rods
      
Note: Threaded rods are typically used for vertical members and as tie rods to secure a lattice assembly to a fume hood wall.      
1/2” dia. x 8” Threaded Rod
1/2” dia. x 10” Threaded Rod
1/2” dia. x 12” Threaded Rod
1/2” dia. x 18” Threaded Rod
1/2” dia. x 24” Threaded Rod
1/2” dia. x 36” Threaded Rod
AAP125-008
AAP125-010
AAP125-012
AAP125-018
AAP125-024
AAP125-036		   SAP125-008
SAP125-010
SAP125-012
SAP125-018
SAP125-024
SAP125-036
Rounded End Rods      
Note: Plain end rods are typically used for vertical and horizontal members.      
1/2” dia. x 5” Rod
1/2” dia. x 8” Rod
1/2” dia. x 12” Rod
1/2” dia. x 24” Rod
1/2” dia. x 36” Rod
1/2” dia. x 48” Rod
1/2” dia. x 60” Rod
1/2” dia. x 72” Rod		 AAP145-005
AAP145-008
AAP145-012
AAP145-024
AAP145-036
AAP145-048
AAP145-060
AAP145-072		 PAP145-005
PAP145-008
PAP145-012
PAP145-024
PAP145-036
PAP145-048
PAP145-060
PAP145-072		 SAP145-005
SAP145-008
SAP145-012
SAP145-024
SAP145-036
SAP145-048
SAP145-060
SAP145-072
Clamps      
Closed style clamps have two 1/2” dia. holes that are perpendicular to each other. They are typically used for securing a lattice rod assembly to a fume hood wall. Open style clamps have one 1/2” dia. hole and an open slot that is perpendicular to it. These clamps are typically used to connect vertical and horizontal rods.      
Closed Style Clamp
Open Style Clamp		 AAP151 AAP153 PAP151
PAP153 		SAP151
SAP153